Description

Hey guys Salz from pcmodbuilds

Finally got Mezmerize up and running, some minor tweeks left and shes 100%

Comments

  • 31 months ago
  • 6 points

I swear I had my pants on a second ago...

  • 31 months ago
  • 2 points

Great build. You could of done some tub bends to save money; you wouldn't of had to spend so much on the joints.

  • 31 months ago
  • 3 points

If you remember the old mezmerize it was all bent tubes.. i specifically wanted this build with straight pipes

  • 31 months ago
  • 1 point

Yeah I learned the hard way about spending money on 90 degree fittings!

  • 31 months ago
  • 1 point

thanks man, appreciate it!

  • 31 months ago
  • 2 points

Great job with your watercooling! Cable management is on point and (I think) you're one of the first to watercool in that magnificent case!

  • 31 months ago
  • 1 point

You should have separated your graphics card of your processor to have better result for your temperature

  • 31 months ago
  • 1 point

GPU & CPU are both idling at 23 degrees Celsius, Even if under load I'm sure it'll be alright. You never know man might change the loop later on ;)

  • 31 months ago
  • 1 point

Because not overclock your temperatures are low (Put the loop of the graphics card in the upper radiator, then in the processor which cools in the radiator which is in front of your PC)

  • 31 months ago
  • 1 point

While I like your idea of separating GPU and CPU loop, I think this case is too small for it.

  • 31 months ago
  • 1 point

It is simple to make just change the stiff tube of your direct graphics board on your radiator which is at the top and of the radiator from above towards the processor and the processor towards the front radiator and the front radiator towards the reservoir or the pump

  • 31 months ago
  • 1 point

That rear cable management is awesome

  • 31 months ago
  • 1 point

Nice build!

Would you be able to post picture for your 8-pin power connector on the top of the mobo and at the bottom of the mobo?

The only reason that is holding me back from getting this case is that this case lacks proper cable management holes on the bottom and top of the mobo tray.

Thank you !

  • 30 months ago
  • 1 point

there is a cable management hole for the 8pin power, see photo 14, but you are right about the bottom, im gonna dremel some holes in the psu shroud to fix that though.

  • 30 months ago
  • 1 point

Thank you for the reply!

I am going to get this case and probably mod the PSU cover as well :)

  • 31 months ago
  • 1 point

Awesome build how to do retain the stock EVGA FTW back plate with the EK water block?

  • 30 months ago
  • 1 point

To your opinion, putting a Raditator - EK-CoolStream XE 360 Triple would be too thick for the front part? ive been thinking such a build, tho i have a spare Raditator - EK-CoolStream XE 360 Triple but not sure if it will fit its like an extra 20mm thick ><

  • 6 months ago
  • 1 point

Looks fantastic and definetely helped my about thinking to upgrade my build.

Can you tell something about the ram clearance?

As I already have an EK PE360 and EK PE240 it is important to be able to keep them. Would they fit with G.Skill trident z?

Or even further (because i cant effort a new mobo, cpu and ram atm) would even the corsair dominator platinum that i own right now fit?

[comment deleted]